Huvitz HLM-1 - General Lens

43
HPE-
8000X
HPE-
8000X
HLM-1
Measurement
9.1. General Lens
How to measure a general lens
① Reset measurement status by pressing ‘CLEAR’ button ( ).
Set measurement lens on the top right corner of the screen to ‘S’. (However, ‘R’
will be displayed if ‘SINGLE LENS’ function is set to ‘Off’ on User Set Up screen.
② Place a lens on the lens cap and slightly move the lens holder upward and down.
③ Move the lens so the prism cross mark is placed on the center of the concentric
circle.
9