0.7
MOVING BANDSAW BLADE WILL CUT
Do NOT operate with guard removed.
Do NOT place hands or ngers near moving bandsaw blade.
For blade changing, always follow the proper Blade Changing Procedure, as given in
Section 3 of this manual.
PINCH POINT
Machine parts may move without warning, either because the machine is operating automatically, or because another
person initiates the motion. Keep hands clear of all labelled pinch points, whenever the machine is running. Machine
vises can exert great force and cause severe injury. Keep hands clear of vises and work piece when vises are opened or
closed. Be aware that vise closing or opening may result in potentially dangerous work piece movement. Be aware also
that the opening motion of a vise may create potential pinch points.
MOVING PARTS CAN CRUSH AND CUT
Keep hands clear of chip auger. Lock-out power in accordance with your com-
pany’s lock-out procedures before attempting to clear a jam in the chip auger.
Be aware that the chip auger may start unexpectedly, either because the
machine is operating automatically, or because another person initiates the
motion.
If the chip auger is stalled because of a jam, it may start without warning when
the jam is cleared, unless the machine power is locked out.
To Next Page
Loading...
Need help?
General
