HYDACELECTRONIC ENS 3000 User Manual

ENS 3000 Page20
Status 21.08.2015 HYDAC ELECTRONIC GMBH Part No. 669850
Setting Displa
y
Setting
range
Default
setting
Analogue output (Output)
The analogue output
provides a 4 .. 20 mA signal for
the active measuring range
MAMP/
VOLT/
MAMP
The analogue output
provides a 0 .. 10 V signal for the
active measuring range
NOTE: relevant for replacement of "previous" devices only
In addition to the probe lengths 410 mm
and 520 mm, when the analogue output
has been assigned to the fluid level.
MA.Sr/
VO.Sr
.
The analogue output provides a
4 .. 20 mA signal for a active
measuring range reduced by 30 mm
.
The analogue output provides a
0 .. 10 mA signal for a active
measuring range reduced by 30 mm
Particular in the variant with 4 SP:
The analogue output provides a
0 .. 10 V signal for the active
measuring range of the fluid level
VOLT/
VO.Sr
VOLTS
.
The analogue output provides a
0 .. 10 mA signal for a active
measuring range reduced by 30 mm
Re-setting the measuring probe to factory settings**
The factory settings are not active YES/ NO NO
The factory settings are active
When the new selection is saved, the message is displayed and the change is
active.

HYDACELECTRONIC ENS 3000 Specifications

General

Brand	HYDACELECTRONIC
Model	ENS 3000
Category	Switch
Language	English