139
8. Warning List
Warning
No.
Warning Picture Cause Action
06A
Impossible to start auto cycle
because chuck open.
CNC chuck is close.
You can’t start auto
cycle.
(when you select chuck
close bar check)
-Touch on <NEXT>.
-Feed bar manually to CNC
and close the chuck.
7
Impossible to start auto cycle
because CNC is not in auto mode.
You didn’t select auto
mode at CNC, so you
can’t start auto cycle.
(when you select Start
bar feeder in CNC auto
mode )
-Touch on <NEXT>.
-Select auto mode and start
cycle.
-If there is still the same
warning, check auto mode
signal.
7A
Impossible to start auto cycle
because CNC is not in auto mode.
You select auto mode
at CNC, so you can’t
start auto cycle.
(when you select after
bar ready CNC send
auto mode)
-Touch on <NEXT>.
-Select manual mode and
start cycle.
To Next Page
Loading...
