Powermax125 Operator Manual 808080 Revision 0 27
Section 2
Power Supply Setup
Unpack the Powermax system
1. Verify that all items on your order have been received in good condition. Contact your distributor if any parts are
damaged or missing.
2. Inspect the power supply for damage that may have occurred during shipping. If there is evidence of damage, refer to
Claims. All communications regarding this equipment must include the model number and the serial number located
on the back of the power supply.
3. Before you set up and operate this Hypertherm system, read the separate Safety and Compliance Manual (80669C)
included with your system for important safety information.
Claims
Claims for damage during shipment – If your unit was damaged during shipment, you must file a claim with the
carrier. Hypertherm will furnish you with a copy of the bill of lading upon request. If you need additional assistance,
call the nearest Hypertherm office listed in the front of this manual.
Claims for defective or missing merchandise – If any component is missing or defective, contact your
Hypertherm distributor. If you need additional assistance, call the nearest Hypertherm office listed in the front of this
manual.
To Next Page
Loading...
Need help?
General
