Hypertherm Powermax125 - Contents; Position the Power Supply

28 Powermax125 Operator Manual 808080 Revision 0
2 – Power Supply Setup
Contents
The following illustration shows typical system components. A vinyl cap is installed on torches that ship with new
systems. Consumables are included in the starter consumable kit, and the small consumables box next to the air filter
contains spare electrodes and nozzles.
Position the power supply
Locate the power supply near an appropriate power receptacle for your installation:
 480 V (3-phase, CSA certified)
 600 V (3-phase, CSA certified)
 400 V (3-phase, CE certified)
 380 V (3-phase, CCC certified)
CSA and CE certified power supplies include a 3 m (10 foot) power cord (depending on the model). CCC certified
power supplies do not ship with a power cord.
or
or
1
2
3
4
5
6
7
8
9
10
11
1
Operator Manual
2
Quick Setup Card
3
Registration card
4
Setup DVD
5
Safety and Compliance Manual
6
Remote-start pendant (optional)
7
Torches
8
Ground clamp and work lead
9
Starter consumable kit
10
Box with extra consumables (located next to air
filter)
11
Power supply