Hypertherm powermax45 Operator's Manual

POWER SUPPLY SETUP
2-2 powermax 45 Operator Manual
Unpack the Powermax45
1. Verify that all items on your order have been received in good condition. Contact your distributor
if any parts are damaged or missing.
2. Inspect the power supply for damage that may have occurred during shipping. If there is
evidence of damage, refer to Claims, below. All communications regarding this equipment must
include the model number and the serial number located on the bottom of the power supply.
3. Before you set up and operate this Hypertherm system, read the Safety and Compliance Manual.
Claims
• Claims for damage during shipment – If your unit was damaged during shipment,
youmust file a claim with the carrier. Hypertherm will furnish you with a copy of the bill
oflading upon request. If you need additional assistance, call the nearest Hypertherm office
listed in the front of this manual.
• Claims for defective or missing merchandise – If any component is missing or
defective, contact your Hypertherm distributor. If you need additional assistance, call
thenearest Hypertherm office listed in the front of this manual.
Contents
Verify the items in the box against the illustration.
Operator Manual
Quick Setup Card
Registration Card
(CSA)
400V (CE)
230V (CE)
Box with extra
consumables
Setup DVD
Remote-start pendant (optional)
Shoulder strap
or

Hypertherm powermax45 Specifications

General

Brand	Hypertherm
Model	powermax45
Category	Welding System
Language	English