Hypertherm powermax45

TORCH SETUP
3-26 powermax 45 Operator Manual
Align the torch
Mount the machine torch perpendicular to the workpiece in order to get a vertical cut. Use a
square to align the torch at 0° and 90°.
Torch
0°
90°
Connect the remote-start pendant
Configurations of a Powermax45 with a T45m also can include a 25-foot (7.62 m), 50-foot (15.24
m), or 75-foot (22.86 m) remote-start pendant. To use the Hypertherm remote-start pendant, plug
it into the receptacle on the rear of the power supply.
Note: The remote-start pendant is for use only with a machine torch. It will not operate if a
handheld torch is installed.
Receptacle for the
remote-start pendant or a
machine interface cable.