Hypertherm powermax45

OPERATION
4-10 powermax 45 Operator Manual
Start a cut from the edge of the workpiece
1. With the work clamp attached to
the workpiece, hold the torch nozzle
perpendicular (90°) to the edge of the
workpiece. If you are using the shielded
consumables, no torch-to-workpiece
standoff is needed. With unshielded
consumables, maintain an approximate
.08-inch (2 mm) standoff.
2. Press the torch’s trigger to start the arc.
Pause at the edge until the arc has cut
completely through the workpiece.
3. Drag the nozzle lightly across the
workpiece to proceed with the cut.
Maintain a steady, even pace.