Hypertherm SYNC Powermax 65 User Manual

Install and Set Up the Plasma Power Supply
2
Powermax65/85/105 SYNC Operator Manual 810470 37
 Put the plasma power supply on a stable,
level surface before using. The plasma
power supply can tip over if set at an angle
greater than 10°.
 Do not put the plasma power supply on its
side. Doing so can cause a blockage of the
air circulation necessary to keep internal
components cool.
>10°

Hypertherm SYNC Powermax 65 Specifications

General

Brand	Hypertherm
Model	SYNC Powermax 65
Category	Welding System
Language	English