What to do if the IAI ASEP Controller displays an overload error?
If the IAI Controller shows an overload error: * Remove any abnormal external force if it is being applied. * Ensure that the brake is released when the servo-motor is turned ON. Possible causes include increased load due to external force, the brake not being released (if applicable), or excessive sliding resistance in the actuator.
What to do if the IAI ASEP Controller displays a software stroke limit over error?
If the IAI Controller shows a software stroke limit over error: * Set the deceleration curve so that an over-chute is not caused when the actuator is stopped. * Return the actuator within the soft limit range and perform the servo-motor turning ON operation. This error can occur if the actuator exceeds the soft limit due to high load or deceleration settings (especially in vertical installations) or if the actuator is moved out of the soft limit range when the servo-motor is OFF.
What to do if the IAI ASEP Controller displays a Z-Phase Detection Time Out error?
If the IAI Controller displays a Z-Phase Detection Time Out error: * Check the actuator cable wiring condition. * Confirm that there is no error in the mechanical part assembly condition. * If the load weight is normal, move the actuator by hand to check the sliding resistance after the power is turned OFF. Potential causes include loose cable connections, brake not released, excessive motor load, or high sliding resistance in the actuator itself.
What to do if there is an overvoltage error in the IAI ASEP Controller?
What to do if there is a position data error in the IAI ASEP Controller movement?
General| Operating Temperature | 0 to 40°C |
|---|---|
| Storage Temperature | -10 to 60°C |
| Vibration Resistance | 4.9 m/s² (0.5 G) or less |
| Protection Class | IP20 |
| Number of Axes | 1 |
| Communication Interface | Ethernet, RS-232C |
| Power Supply | 24V DC |
| Humidity | 20 to 80% RH (non-condensing) |
| Control Method | Position, Speed, and Torque Control |
| Programming Language | Proprietary language (IAI language) |
To Next Page
