12
[Operation]
Turn on the power to individual equipment one by one, starting from the equipment at the highest
level in the system hierarchy. Failure to do so may cause the product to start suddenly, resulting in
injury or product damage.
Do not insert a fi nger or object in the openings in the product. It may cause fi e, electric shock or
injury.
Do not bring a fl oppy disk or other magnetic media within one meter of the product. The magnetic
fi eld generated by the magnet may destroy the data in the fl oppy disk, etc.
[Maintenance, Inspection, Repair]
When the power was turned off and the cover was opened to replace the battery, etc., do not touch
the condenser terminal in the product immediately after the power was turned off (within 30 seconds).
Residual voltage may cause electric shock.
Do not touch the terminals when performing an insulation resistance test. Electric shock may result.
(Do not perform any withstand voltage test, since the product uses DC voltage.)
Note
[General]
If you are planning to use the product under a condition or environment not specifi ed in the catalogs
and operation manual, or in an application requiring strict safety such as aircraft facility, combustion
system, entertainment machine, safety device or other equipment having signifi cant impact on
human life or property, design operating ranges with suffi cient margins from the ratings and design
specifi cations or provide suffi cient safety measures such as fail-safes. Whatever you do, always
consult IAI’s sales representative.
[Installation]
Do not place objects around the controller that will block airfl ows. Insuffi cient ventilation may damage
the controller.
Do not confi gure a control circuit that will cause work to drop in case of power failure. Confi gure a
control circuit that will prevent the table or work from dropping when the power to the machine is cut
off or an emergency stop is actuated.
[Installation, Operation, Maintenance]
When handling the product, wear protective gloves, protective goggles, safety shoes or other
necessary gear to ensure safety.
[Disposal]
When the product becomes no longer usable or necessary, dispose of it properly as an industrial
waste.
IAI shall not be liable whatsoever for any loss or damage arising from a failure to observe the items
specifi ed in “Safety Precautions.”
To Next Page
Loading...
Need help?
General
