3
Our Models regarded as Industrial Robots
The products which come under the following conditions, are excluded from the Industrial Robot
category according to the notice from the Ministry of Labor and the notification issued by the
director general of the Labor Standards Bureau in the Ministry of Labor (No. 340).
(1) Single-axis robot product with the motor wattage of 80W or less
(2) Multi-combined shaft robot product with the length of X, Y, and Z-axis of 300 mm or less and, if
there is any rotary section, the maximum movable range is 300 cubic mm or less including the
end section of the rotary section.
(3) Articulated robot product with both the movable radius and the length of Z-axis of 300 mm or
less.
Our models regarded as the industrial robots among the products in our catalogue are as follows.
1. Single Axis ROBO CYLINDER
RCS2/RCS2CR-SS8 with the stroke exceeding 300 mm
2. Single Axis Robot
Following models with the stroke exceeding 300 mm and motor capacity exceeding 80W
ISPDA, ISWA/ISPWA, IF, FS, NS
3. Linear Servo-Actuator
All the models with the stroke exceeding 300 mm
4. Cartesian-Type Robot
Any of the models in Item 1 through Item 3, which can be used on a single axis
5. IX SCARA Robot
6. Vertical Articulated Robot AR Series
IX-NNN (NNW, NNC) 3515
IX-NNN (NNW, NNC) 50 /60 /70 /80
IX-NSN5016/6016
IX-TNN (UNN) 3015/3515
IX-HNN (INN) 50 /60 /70 /80