Safety Guide
Intro-5
ME0416-1A
6 Trial
Operation
● When working with two or more persons, make it clear who is to be in charge
and communicate well with each other to ensure safety.
● After teaching or programming, carry out trial operation step by step before
switching to automatic operation.
● When trial operation is to be performed inside the safety/protection fence, use
the same work procedure, determined in advance, as teaching operation.
● Be sure to confirm program operation at safe speeds. Otherwise, this may
lead to accidents due to unexpected motion caused by program error, etc.
● Do not touch the terminal block or any of the various setting switches while
the equipment is live. Otherwise, this may lead to electric shock or abnormal
Operation
● Check before starting automatic operation or restarting after operation stop
that there is nobody within the safety/protection fence.
● Before starting automatic operation, make sure that all peripheral equipment
is ready for automatic operation and that there is no alarm indication.
● Be sure to start automatic operation from outside the safety/protection fence.
● If the product produces abnormal heat, smoke, odor, or noise, immediately
stop it and turn OFF the power switch. Otherwise, this may lead to fire or
damage to the product.
● When a power failure occurs, turn OFF the power switch. Otherwise, this may
lead to injury or product damage due to unexpected product motion during
recovery from the power failure.
To Next Page
Loading...
Need help?
General