IAI RCON-LC User Manual

Safety Guide
ME0416-1A Intro-6
No.
Operation
Precautions
8 Maintenance
and
Inspection
● When working with two or more persons, make it clear who is to be in charge
and communicate well with each other to ensure safety.
● Perform the work outside the safety/protection fence, if possible. If operation
must be performed within the safety/protection fence, prepare "Work
Regulations" and make sure that all the workers acknowledge and understand
them well.
● When work is to be performed inside the safety/protection fence, turn OFF the
power switch as a rule.
● When operation is to be performed inside the safety/protection fence,
operators should have emergency stop switches available at hand so that the
unit can be stopped at any time if abnormalities occur.
● When operation is to be performed inside the safety/protection fence, have a
monitor standing by in addition to the operator(s) so that the unit can be
stopped at any time if abnormalities occur. Also, keep watch on the operation
so that a third party cannot operate the switches carelessly.
● Place a sign indicating "Operating" where it can be seen easily.
● For the grease for the guide or ball screw, use appropriate grease according
to the Instruction Manual for each model.
● Do not perform dielectric strength testing. Otherwise, this may lead to damage
to the product.
● When releasing the brake on a vertically oriented actuator, be careful that it
does not fall under its own weight, catching the operator's hand or damaging
workpieces.
● The slider or rod may be misaligned from the stop position if the servo is
turned OFF. Avoid injury or damage due to unnecessary operation.
● Be careful not to lose the cover or any removed screws, and be sure to return
the product to the original condition after maintenance and inspection work.
Otherwise, this may lead to product damage or injury due to incomplete
mounting.
* Safety/protection fence: If there is no safety/protection fence, the movable
range should be indicated.
9
Modification
and
Disassembly
● Do not modify, disassemble/assemble, or use maintenance parts not specified
on your own discretion.
10 Disposal ● When the product exceeds its useful life or is no longer needed, dispose of it
properly as industrial waste.
● When removing the actuator for disposal, avoid dropping components when
detaching screws.
● Do not put the product in a fire when disposing of it. The product may rupture
or generate toxic gases.
11
Other
● If you are equipped with a medical device such as a pacemaker, do not
approach the product or its wiring, as the device may be affected.
● See the Overseas Standard Compliance Manual to check compliance with
overseas standards if necessary.
● For the handling of actuators and controllers, follow the dedicated instruction
manual of each unit to ensure safety.

IAI RCON-LC Specifications

General

Brand	IAI
Model	RCON-LC
Category	Control Systems
Language	English