(continued)
service manual or a device not supported by IBM diagnostic tests.
If all devices and adapters have been removed, and the problem remains:
1. Remove all cables from connectors on the system board except the
power supply and switch cables.
2. Remove all SIMMs from sockets.
3. Power on the system unit and listen for any beeps.
Note: Make sure the system board speaker is enabled. See “System
Board Layout—Type I-1” on page 5-2 and “System Board
Layout—Type I-2” on page 5-5.
4. If there are beeps, replace the system board and use the current
processor on the replacement FRU system board.
5. If there are no beeps, replace the processor and use the current system
board.
6. If there are still no beeps, replace the current system board and use the
FRU processor obtained in step 5.
2-64
To Next Page
Loading...
Need help?
General