6. To end (RUN TEST CONTINUOUSLY), press and hold the Ctrl key;
then press the Break key. The system completes testing and returns to
the Installed Devices menu.
Display the Error Log
1. Depending on the options installed in the system, questions about
attached devices appear on the screen. Answer as required; then press
Enter.
2. Press Y or N (IS THE LIST CORRECT (Y/N)?), then Enter.
3. Press 2 (LOG UTILITIES), then Enter.
4. Press 2 (DISPLAY LOG), then Enter.
5. Press A or B (ENTER THE DRIVE ID FOR ERROR LOG?), then Enter.
6. If no errors occurred, the Log Utilities menu appears. If errors are
displayed, go to “Start” on page 2-2.
Diagnostic Aids 3-11
To Next Page
Loading...
