Connecting your 5065 Expansion Unit in a loop
Use this procedure to connect your 5065 to an expansion unit which is already
connected to your system unit. Your system unit should be powered down before
you proceed. If your system unit is not powered down, read “Powering down
your AS/400 system unit” on page 5 and power down your system unit.
To make this procedure simpler, refer to the other expansion unit as unit X, as is
shown in Figure 13.
Figure 12. Install Back Cover
Figure 13. Connecting your 5065 to another expansion unit
12 Setting Up Your 5065 or 5066 Expansion Unit V4R5
To Next Page
Loading...
Need help?
General