Chapter 5. Verifying Your New Configuration
Verify your new configuration by performing the following:
__ 1. On an AS/400 command line, type:
STRSST
Press the Enter key.
__ 2. When the Start a Service Tools menu appears, select the Start a service tool
option.
Press the Enter key.
__ 3. When the Start a Service Tool menu appears, select option 7 (Hardware
service manager).
Press the Enter key.
__ 4. When the Hardware Service Manager menu appears, select the Packaging
hardware resources (system, frames, cards...) option.
Press the Enter key.
Your new expansion unit appears on the list. If it does not, you need to
verify your installation by performing these steps:
a. Make sure that you powered on the expansion unit.
b. Make sure that you connected the optical cables correctly.
c. Make sure that you connected the SPCN cables correctly.
__ 5. For future reference, print the configuration list and place it in this book. To
print the configuration list proceed as follows:
a. You need to sign on with service authority.
b. On the AS/400 Main menu command line type:
STRSST
Press the Enter key.
c. On the STRSST display, select option 1 (Start a service tool).
Press the Enter key.
d. On the Start a Service Tool display, select option 7 (Hardware service
manager).
Press the Enter key.
e. From the Hardware Service Manager display, press F6 (print the
configuration).
Updating Vital Product Data
You need to update the Vital Product Data (VPD) for your system now that your
installation is complete. You should still be at the Hardware Service Manager
display. If you are not, follow steps 5b through 5d above. Do the steps below:
__ 1. At the Hardware Service Manager display, select option 5 (System power
control network (SPCN)).
__ 2. Press the Enter key.
__ 3. Locate your expansion unit on the System Configuration List that you
printed in step 5e.
© Copyright IBM Corp. 1999, 2000 25
To Next Page
Loading...
Need help?
General