IBM AS/400e

a. Fill the slot 1’s: D31, D36, D46
b. Fill the slot 2’s D32, D37, D47
c. Fill the slot 3’s: D33, D38, D48
d. Fill the slot 4’s: D34, D39, D49
e. Fill the slot 5’s: D35, D40, D50
2. Your expansion unit requires a second high speed disk unit controller before
you can install disk units into the following positions. Contact IBM or an
Authorized Dealer if your expansion unit does not have a second high speed
disk unit controller (IOA Card 2).
Next fill the slots in (IOA Card 2) this sequence:
a. Fill the slot 1’s: D01, D11, D21
b. Fill the slot 2’s: D02, D12, D22
c. Fill the slot 3’s: D03, D13, D23
d. Fill the slot 4’s: D04, D14, D24
e. Fill the slot 5’s: D05, D15, D25
3. Your expansion unit requires a third high speed disk unit controller before you
can install disk units into the following positions. Contact IBM or an
Authorized Dealer if your expansion unit does not have a third high speed disk
unit controller (IOA Card 3).
Last fill the slots in (IOA Card 3) this sequence:
a. Fill the slot 1’s: D06, D16, D26
b. Fill the slot 2’s: D07, D17, D26
c. Fill the slot 3’s: D08, D18, D28
d. Fill the slot 4’s: D09, D19, D29
e. Fill the slot 5’s: D10, D20, D30
Installing a disk unit
Follow these steps to install a disk unit. If you encounter difficulties during the
installation, contact your authorized dealer or service provider.
__ 1. Is your main system-unit powered off?
No Yes
↓ Go to step 4 on page 48.
__ 2. Refer to Figure 33 on page 39 (5065) or Figure 34 on page 40 (5066) and use
the latch that is shown at A to open the front cover.
__ 3. If needed, use the latch that is shown at B to remove the front cover.
38 Setting Up Your 5065 or 5066 Expansion Unit V4R5