D10 Fan
Before performing the following procedure, read “Safety Considerations” on page 53.
Hot-Swap Fan Assembly Removal
To remove a hot-swap fan, do the following:
1. Locate the cooling fan assembly on the front of the I/O subsystem.
2. Unscrew the thumbscrew that holds the fan into the I/O subsystem.
3. Pull the fan assembly straight out until it is clear of the I/O subsystem.
1
2
1 Fan 2 Thumbscrew
Hot-Swap Fan Assembly Replacement
To replace your subsystem’s hot-swap fan, do the following:
1. Position the fan with the connector (located on the fan housing) facing in toward the
I/O subsystem.
2. Insert the replacement fan assembly into the I/O subsystem as far as possible.
3. Screw in the thumbscrew to hold the fan in position.
120 Eserver pSeries 7311 Model D10 and Model D20 Service Guide
To Next Page
Loading...
