PCI Adapter or Blank Filler Removal From a Cassette Assembly
This procedure is performed when preparing to install or replace an adapter or an
adapter blank filler in your subsystem.
Note: An adapter or an adapter blank filler must be installed into the PCI adapter
cassette assembly before it is reinstalled in a system unit or a subsystem.
Determine the slot of the system or subsystem in which you plan to install or remove an
adapter, and refer to the procedures for removing an adapter from the system. Remove
the PCI adapter cassette assembly from the system unit or subsystem before beginning
this procedure.
Note: It may take approximately 30 to 40 minutes to perform this procedure the first
time. This time includes following the written procedure and performing the
steps. Performing this procedure thereafter usually takes approximately 10
minutes.
Before performing the following steps, familiarize yourself with the entire procedure.
To remove a PCI Adapter or blank filler from a cassette assembly, do the following:
1. Place the PCI adapter cassette assembly on a flat work surface with the cover
facing up, and the top of the adapter facing you, see the following illustration.
1 Cover 3 Top of Cover
2 Handle
74 Eserver pSeries 7311 Model D10 and Model D20 Service Guide
To Next Page
Loading...
Need help?
General