IBM eserver pSeries 7311 D10 User Manual

Service Access Cover Removal
If you need to remove the service access cover from the subsystem, do the following:
1. Open the cover as described in the above procedure.
2. Remove the four retaining screws that secure the cover hinge to the chassis.
3. Remove the cover.
Service Access Cover Replacement
To install the service access cover, do the following:
1. Open the piano hinge, located on the service access cover.
2. Align the four holes located on the piano hinge with the four screw holes located on
the top of the chassis.
3. Start then tighten the four retaining screws that secure the service access cover to
the chassis.
4. Close then secure the service access cover with the three thumbscrews located on
its back edge.
128 Eserver pSeries 7311 Model D10 and Model D20 Service Guide

IBM eserver pSeries 7311 D10 Specifications

General

Brand	IBM
Model	eserver pSeries 7311 D10
Category	Server
Language	English