IBM eserver pSeries 7311 D10 User Manual

Front Bezel Replacement
To replace the front bezel, do the following:
1. Open the front rack door. If necessary, put the Model D20 subsystem into the
service position as described in “D20 Service Position” on page 125.
2. Insert the two tabs located on the bottom edge of the bezel into their locking slots,
located on the chassis.
3. Pivot the front bezel up toward the top of the chassis.
4. Align the release tabs to the matching slots located on the front of the subsystem
chassis.
5. Gently push the tabs into the slots until the bezel seats against the front of the
subsystem.
6. If the subsystem is in the service position, push the subsystem back into the
operating position as described in “D20 Operating Position” on page 126.
7. Close the rack door.
130 Eserver pSeries 7311 Model D10 and Model D20 Service Guide

IBM eserver pSeries 7311 D10 Specifications

General

Brand	IBM
Model	eserver pSeries 7311 D10
Category	Server
Language	English