14. Replace all of the previously removed PCI adapters as described in “Adding or
Replacing a Non-Hot-Pluggable PCI Adapter” on page 147.
Note: Alternately reinstall the PCI dividers, when reinstalling the PCI adapters.
15. Reconnect all PCI adapter cables to their respective adapters.
16. Reconnect the power cables to the power supplies.
17. Reconnect the power source to the system. The green LED located on the power
supply comes on solid.
18. Close then secure the service access cover with the three thumbscrews located on
its back edge.
19. Push the Model D20 subsystem back to the operating position as described in
“D20 Operating Position” on page 126.
20. After the system has successfully powered on, close the rack doors.
178 Eserver pSeries 7311 Model D10 and Model D20 Service Guide
To Next Page
Loading...
Need help?
General