16. Press the Tab key until the entry field displays the remove operation and then
Press the Enter key. Follow the instructions that display on the screen until you are
instructed to remove the adapter.
17. When you are instructed to remove the adapter from the adapter slot, disconnect
any cables that are connected to the adapter being removed.
18. Press the center of the handle of the PCI card cassette to release the latch, then
lower the handle completely.
19. When the handle is completely lowered, push the gray locking cross bar.
20. Carefully pull the PCI adapter cassette straight out from the I/O subsystem, as
shown in the following illustration. Take care not to pull EMC gaskets from
neighboring cassettes.
1 I/O Subsystem 2 PCI adapter Cassette
21. If you are not installing another adapter in this slot, install a blank PCI adapter
cassette into the slot.
22. Continue to follow the screen instructions until you receive a message that the
adapter removal is successful. Successful removal is indicated by the OK message
displayed next to the Command field at the top of the screen.
23. If you do not have other adapters to remove, continue with the next step.
OR
If you have other adapters to remove, press the F3 key to return to the PCI
Hot-Plug Manager menu and then return to step 14 on page 67.
24. Press F10 to exit the Hot-Plug Manager.
25. Install any covers that you removed earlier, and return the drawer to the normal
operations.
68 Eserver pSeries 7311 Model D10 and Model D20 Service Guide
To Next Page
Loading...
