v E = 16-way VPD
v F = 24-way VPD
v G = 32-way VPD
3. Locate the card that must be replaced.
4. Remove the card, and if it is a VPD card, the associated MCM or L3 modules.
5. Replace the card in reverse order (and if it is a VPD card, the new MCM or L3 modules).
6. Perform a manual IPL to DST. If the system stops at the System Password Required screen, DO NOT
BYPASS. Contact your next level of support to obtain a System Password and enter it on this screen.
Note: DST/SST options to activate POD will not be visible if the system password has been bypassed.
7. If you are replacing a processor capacity card that was associated with processor-on-demand (POD)
processor features, perform the following:
a. Contact your second level of support to determine if a POD activation code is required to reset
previously activated on-demand processors.
b. If necessary, a new POD activation code will need to be generated and then entered at the server.
c. After entering a POD activation code, 30 minutes should elapse before an IPL is performed to
ensure the POD activation code has been saved.
Attention: The POD activation code or codes must be entered within 48 hours or an SRC A6XX
47XX will be posted in the panel requiring an IPL and, or LPAR configuration adjustments.
8.
Return to the procedure that sent you here.
This
ends the procedure.
FC 5074, FC 5079, FC 8079, FC 9074, FC 9079 remove and replace
procedures
For use by authorized service providers.
FC 5074, FC 5079, FC 9079 (with single line cord) - AC charger - A01
FC 5074, FC 5079, FC 9079 (with dual line cord) - AC module - A01 and A02
FC 5074, FC 5079, FC 9074, FC 9079 - Air moving device - B01 and B02
FC 5074, FC 5079, FC 9079 - Batteries - T01, T02, T03, and T04
FC 5074, FC 5079, FC 5094, FC 5294 - Cards (concurrent)
FC 5074, FC 5079, FC 5094, FC 5294 - Cards (dedicated)
FC 5074, FC 5079, FC 5094, FC 5294, FC 9079, FC 9094 - Covers
FC 5074, FC 5079, FC 9079 - Device board - DB1 and DB2
FC 5074, FC 5079, FC 9079 - Device board - DB3
FC 5074, FC 5079 - Disk unit (concurrent)
FC 5074, FC 5079 - Disk unit (dedicated)
FC 5074, FC 5079 - Display panel - NB1
FC 5074, FC 5079, FC 9079 - Power distribution board - PB1
FC 5074, FC 5079, FC 9074, FC 9079 - Power supply - P01, P02, and P03
136 Hardware (Remove and Replace; Part Locations and Listings)
To Next Page
Loading...
