Note: To the right of the description field you will see one or both of the following symbols displayed.
Symbol Indication
* Indicates the location to which the system will assign the resource.
> Indicates the location to which the resource was last assigned.
3. Press Enter. The Work with Controlling Resources display will appear.
4. Determine the location where you want to assign the resource and select Assign to for that location.
5. Wait for the Hardware Resource Concurrent Maintenance display to appear with the message
indicating power on complete.
6. After exchanging the failing item, go to Verify the repair.
Note: If you have exchanged a 2766 or 2787 Fibre Channel IOA, the IBM 2105 disk unit subsystem
must be updated to use the World-Wide Port-Name of the new 2766 or 2787 IOA. This name can be
found in the Port worldwide name field on the iSeries by displaying detail on the 2766 or 2787 IOA
Logical Hardware Resource information in Hardware Service Manager in SST/DST.
The 16-digit World-Wide Port-Name can also be determined by appending the digits ″1000″ to the
beginning of the 12-digit IEEE Address found on the tailstock label of the Fibre Channel IOA. Use the
ESS Web Interface User’s Guide (SC26-7346) to update the World-Wide Port-Name in the host
configuration on the IBM 2105 ESS. The ESS Web Interface User’s Guide can also be found at the
following URL: http://ssddom02.storage.ibm.com/disk/ess/documentation.html
This
ends the procedure.
FC 5075 - Cards (dedicated)
For use by authorized service providers.
Use this procedure to remove or replace the cards (dedicated) in the FC 5075.
In some cases, you do not need to power down the system to change PCI cards. Use the guidelines in FC
5075 - Cards (concurrent) to determine if you should use dedicated or concurrent remove and replace
procedures.
CAUTION:
The circuit card contains lead solder. To avoid the release of lead (Pb) into the environment, do not
burn. Discard the circuit card as instructed by local regulations. (RSFTC234)
Attention: All cards are sensitive to electrostatic discharge (see Work with electrostatic discharge-sensitive
parts).
To remove or replace cards (dedicated):
1. Power off the expansion tower. See the Expansion unit power procedure.
2. Remove the ac power cord from the frame you are working on.
3. Remove the right side cover. See FC 5075 - Covers.
4. Remove and label any cables connected to the card.
5. Turn the latches to secure the card.
6. Gently pull the card off the system backplane.
7. Reverse this procedure to install the card. After exchanging a failing item, go to Verify the repair.
Note: If you have exchanged a 2766 or 2787 Fibre Channel IOA, the IBM 2105 disk unit subsystem
must be updated to use the World-Wide Port-Name of the new 2766 or 2787 IOA. This name can be
found in the Port worldwide name field on the iSeries by displaying detail on the 2766 or 2787 IOA
Logical Hardware Resource information in Hardware Service Manager in SST/DST.
The 16-digit World-Wide Port-Name can also be determined by appending the digits ″1000″ to the
beginning of the 12-digit IEEE Address found on the tailstock label of the Fibre Channel IOA. Use the
ESS Web Interface User’s Guide (SC26-7346) to update the World-Wide Port-Name in the host
Analyze hardware problems 157
To Next Page
Loading...
