Step 1540-24
Replace the adapter you just installed with a new adapter and retry the boot to standalone diagnostics
from CD.
1. If the Please define the System Console screen is displayed, follow directions to select the system
console.
2. Use the Display Configuration and Resource List to list all attached devices and adapters (refer to the
RS/6000 and Eserver pSeries Diagnostic Information for Multiple Bus Systems if necessary).
3. Check that all attached devices and adapters are listed.
Did the Please define the System Console screen display and are all attached devices and adapters
listed?
NO The I/O drawer backplane is defective. Replace the I/O drawer backplane; then continue below.
YES The adapter was defective. Continue below.
Go
to “Step 1540-26” on page 127.
Chapter 3. Maintenance Analysis Procedures 125