Modem Configuration Menu
The first two lines of the Modem Configuration Menu are status lines showing the current selections.
Selections are made in the two sections labeled Modem Ports and Modem Configuration File Name.
Select the serial port that you want to activate and then select the modem configuration file for the modem
on the port. If you want to set up both of the serial ports with modems, make your selections one port at a
time.
Note: Modem configuration is only supported on serial port 1 (S1) and serial port 2 (S2).
Modem Configuration Menu
Port 1 Modem Configuration File Name:
Port 2 Modem Configuration File Name:
To make changes, First select the port and then the configuration file
name
Modem Ports:
1. Serial port 1
2. Serial port 2
Modem Configuration File Name:
5. none 9. modem_z_sp
6. modem_f_sp 10. modem_m1_sp
7. modem_f0_sp 11. modem_m0_sp
8. modem_f1_sp 12. modem_m1_sp
30. Save configuration to NVRAM and Configure modem
98. Return to Previous Menu
0>
For information on choosing a modem configuration file, see “Sample Modem Configuration Files” on page
509, and “Transfer of a Modem Session” on page 515.
Chapter 8. Using the Service Processor 381
To Next Page
Loading...
Need help?
General