Adapter Parameters
Select the Adapter Parameters option from the Network Parameters menu to view an adapter’s hardware
address, as well as configure network adapters that require setup. A screen similar to the following
displays when you make this selection:
Adapter Parameters
Device Slot Hardware Address
1. Gigabit Ethernet 4: P1-I4/E1 0004ac7c0135
2. token-ring 5: P1-I5/T1 0020357a9105
3. ethernet Integrated:P1/E1 0060949d7ac5
4. ethernet 2: P1-I2/E1 0004ac5e692b
5. token-ring 3: P1-I3/T1 0004ac634e38
.------.
|X=Exit|
`------’
(PRESS ENTER AFTER MAKING A SELECTION) ===>
Select an adapter on this screen to display configuration menus for that adapter. If ethernet is selected,
you can set parameters that control how the ethernet adapter communicates with the network. For
example, the following screen shows the menu for the ethernet adapter configuration:
1. Data Rate [Auto]
2. Full Duplex [No]
Chapter 9. Using System Management Services 405
To Next Page
Loading...
Need help?
General