Select Boot Devices
Select this option to view and change the custom boot list, which is the sequence of devices read at
startup time. The boot list can contain up to five devices. The following is an example of this screen.
Select Boot Devices
1 Display Current Settings
2 Restore Default Settings
3 Configure 1st Boot Device
4 Configure 2nd Boot Device
5 Configure 3rd Boot Device
6 Configure 4th Boot Device
7 Configure 5th Boot Device
.------.
|X=Exit|
`------’
====>
Display Current Settings
Lists the current order of devices in the boot list. The following is an example of this screen.
Current Boot Sequence
1. Diskette
2. SCSI CD-ROM ( loc=P1/Z1-A1 )
3. SCSI 9100 MB Harddisk ( loc=P1/Z1-A5 )
4. Ethernet ( loc=P1-I4/E1 )
5. None
.------.
|X=Exit|
`------’
===>
Restore Default Settings
Restores the boot list to the following default sequence:
v Primary diskette drive
v CD-ROM drive
v Tape (if installed)
v Hard disk drive
v Network device
Chapter 9. Using System Management Services 409
To Next Page
Loading...
Need help?
General