Table 6. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
25A8 0211 Setenv/$Setenv parameter error - value
contains a null character.
Refer to Action under error code 25A80xxx.
25A8 0998 NVRAMRC script evaluation error - command
line execution error
Execution of a command line within the
nvram configuration variable “nvramrc”
(script) resulted in a “throw” being executed.
This script can be modified by the system
firmware SMS utilities, the operating system,
PCI adapter rom code or utility, or an
operator (via the open firmware script editing
command “nvedit”). It may not be possible to
resolve the problem without a detailed
analysis of the nvram script, the current
system configuration, and device tree
contents.
1. The problem can be caused by a SCSI
adapter, whose SCSI bus ID has been
changed from the default setting, no
longer appearing in the system. This can
be caused either by removing a SCSI
adapter, or a problem with a SCSI
adapter.
a. Select the SCSI ID utility from the
SMS menu(s).
1) Verify the list of SCSI
controllers/adapters. If the list is
not correct, suspect a problem
with the adapter(s) installed but
not listed.
2) Select the option to Save the
configuration information.
3) Restart the system.
b.
If the problem persists, boot the
operating system and verify the SCSI
bus IDs of any installed/available
SCSI controllers (change as
necessary), and restart the system.
2.
Contact your support representative for
further assistance.
25A8 0999 NVRAMRC script evaluation error - stack
unbalanced on completion
This is a firmware debug environment error.
There is no user action or FRU replacement
for this error.
Chapter 5. Error Code to FRU Index 203
To Next Page
Loading...
Need help?
General