Table 6. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
2B20 0022 Processor is deconfigured by the system. 1. Replace the processor card at the
location specified in the error log.
See “Determining Location Code” on
page 160 for location code information
related to this error.
2. CEC backplane
Location: U1.1-P1
2B2x xx31 Processor is failing POST Replace the processor card at the location
specified in the error log.
See “Determining Location Code” on page
160 for location code information related to
this error.
2B20 0031 Processor is failing POST or is manually
disabled.
1. If the processor is not enabled, then use
the service processor menus to enable
the processor. Then reboot the system.
2. If the processor is failing POST, then
replace the processor card at the location
specified in the error log.
See
“Determining Location Code” on page
160 for location code information related to
this error.
2B20 0042 Unknown processor card Remove the unknown processor card.
2BA0 0000 Service processor POST failure Replace primay I/O drawer backplane
Location: U0.1-P1
2BA0 0012 Service processor reports self test failure Replace primary I/O drawer backplane
Location: U0.1-P1
2BA0 0013 Service processor reports bad NVRAM CRC If problem persists, replace primary I/O
drawer backplane
Location: U0.1-P1
2BA0 0017 Service processor reports bad or low battery. 1. Replace the battery
Location: U0.1-P1-V3
2. Replace primary I/O drawer backplane
Location: U0.1-P1
2BA0 0041 Service processor VPD is corrupted. Replace primary I/O drawer backplane
Location: U0.1-P1
208 Service Guide
To Next Page
Loading...
Need help?
General