Hot-swap power supply
If you install or remove a hot-swap power supply, observe the following precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
To remove a hot-swap power supply, complete the following steps.
Power supply filler
Release latch
Power supply
1. Read the safety information that begins on page vii and “Handling
static-sensitive devices” on page 57.
72 IBM System x3500 Type 7977: Problem Determination and Service Guide
To Next Page
Loading...
