Using a docking station
For an ISA adapter card:
1
Open Windows 98 or Windows 95 Device Manager,
and check the resources available for the new card.
2
Disconnect the AC Adapter from the SelectaBase 600
port replicator.
3
Set the jumper or the DIP switches on the adapter card.
For an IDE device such as a hard disk drive or a CD-ROM
drive:
1
Start the ThinkPad Configuration program, and click the
Docking Station (
) button.
2
Click the IDE Device tab.
3
Select Enable in the IDE device in the Docking
Station list box (if you haven't already), and restart the
computer.
4
Click Device Manager and check whether there is a
resource conflict between the new IDE device and the
other devices in the computer. If there is a resource
conflict, see the
Online User's Guide
.
Before you do the following steps, read “Enabling the
IDE drive on the docking station.”
Enabling the IDE drive on the docking station
If you have installed an IDE device (such as a hard disk drive or a
CD-ROM drive) in the docking station, you must change the setting
on your computer to enable the device. By default, your computer
uses the primary IDE channel for the primary hard disk drive
(primary-master) and the secondary IDE channel for a device in the
UltraslimBay (secondary-master). You cannot use the IDE device
in the docking station in this default 2-channel default IDE mode.
84 IBM ThinkPad 600X User's Reference
To Next Page
Loading...
Need help?
General
