Note: This procedure is optional.
To set up email notifications of library events:
1. In the Configure Library menu in the left navigation panel of the Web User Interface, click SMTP.
2. Configure the Send server settings.
SMTP server address - SMTP mail server address. IPv4 and IPv6 addresses are supported. Host names can be entered instead of numerical IP addresses if
the DNS server is specified in the Network settings.
Sender address - Mail header information.
Subject - Mail header information.
3. Enter the email addresses to be notified when an event takes place in the Mail To fields, and click the Enable check boxes to select each address.
4. Select the event level to report in the Mail Event settings.
5. Click Test to send a test email message to the enabled addresses.
6. Click Submit to enable the settings.
Configuring SNMP notifications
SNMP notifications can be configured for this library.
Figure 1. Trap notifications
To Next Page
Loading...
Need help?
General