12. Remove the flat-head screws 6 on each side to remove the left 5 and right 3 rails from the chassis (Figure 5)
Figure 5. Removing side rails from the library chassis
Installing the library in a rack
For details on the rack mount kit components, see Installing in a rack.
1. Determine the location in your rack for your library and mark with a pencil. For details on rack mount locations, see Installing in a rack.
2. Attach the left 3 and right 4 front brackets to the front of the library chassis with 2 flat-head screws 8 on each side (Figure 6). Use the bottom two screw holes on
each side.
Figure 6. Attaching the front brackets to the library chassis
3. Attach the left 1 and right 2 rear brackets to the left 5 and right 6 front rails with 2 round-head screws 10 on each side (Figure 7).
Note: Run the hook-and-loop fastener strap through the slot on the right rear bracket and attach it back upon itself.
Figure 7. Attaching the rear brackets to the rails
4. Slide in the rear rails 7 from back to front to create the rail assemblies. Ensure that the screw holes face outwards (Figure 8).
Figure 8. Attaching the rear brackets to the rails
To Next Page
Loading...
