Task Web User Interface Operator Panel
Task Web User Interface Operator Panel
Move cartridges
*
Manage Library > Move Cartridges
Two methods to move cartridges between the I/O station, storage positions, and tape
drive:
Click and drag a cartridge from one location to another.
Click a cartridge, select location coordinates from the Destination slot menu,
and click Move.
Commands > Move Cartridge
Specify the Source Slot and the Destination Slot and
press Enter.
Graphical view of
cartridges
Monitor System > Library Map. See Graphical view of library. Not available with this interface
View library inventory Manage Library > Inventory Commands > Inventory
* Cartridges cannot be moved to the accessor with this command. However, cartridges can be moved from the accessor with this command if the library was powered
OFF with a cartridge still held in the accessor.
Table 6. Managing security
Task Web User Interface Operator Panel
Upload certificates Configure Library > Certificate. See Uploading and configuring the SSL
certificate.
Not available with this interface
Configure encryption Configure Library > Encryption . See Configuring encryption. Not available with this interface
Modify users Configure Library > User Access. See Managing user access. Not available with this interface
Add users Configure Library > User Access. See Managing user access. Not available with this interface
Remove users Configure Library > User Access. See Managing user access. Not available with this interface
Enable or disable SSL for
Web
Configure Library > Network. See Configuring network settings. Not available with this interface
Configure Web GUI
settings
*
Not available with this interface Configuration > Configure Web GUI settings > Unlock a User
Account
* In case you forget the password of a user account, you can reset the password using the Configure Web GUI settings. The password of the user account unlocked is
changed to secure automatically.
Default settings
The library is set to default settings when first purchased. Many of these settings can be customized.
Updating library and drive firmware
Methods of cleaning the tape drive
Automatic cleaning of the tape drive is disabled by default in the library. It is also possible to clean the drive manually. However, automatic cleaning of the tape
drive is recommended for the library.
Default settings
The library is set to default settings when first purchased. Many of these settings can be customized.
Table 1. Default library configuration settings
Configuration Item Default Setting
NETWORK
Ethernet link speed Auto
SSL security Disabled
IPv4 settings Enabled
DHCP (Dynamic Host Configuration Protocol) Enabled
Static IP address Disabled
IPv4 address 0.0.0.0
Subnet mask 255.255.255.0
Gateway 0.0.0.0
IPv6 settings Disabled
DHCP (Dynamic Host Configuration Protocol) Enabled
Stateless auto-configuration Enabled
Static IP address Disabled
IPv6 address 0:0:0:0:0:0:0:0
Prefix length 64
Gateway 0:0:0:0:0:0:0:0
DNS setting Disabled
DNS IP address 0.0.0.0
PHYSICAL
Library name (Blank)
Auto Cleaning Disabled
Bar code label length 8 characters
LOGICAL
Library mode Random
Loop Enabled
Auto Load Enabled
Active slots 9 + 0
ENCRYPTION (S4H and LATER ONLY)
To Next Page
Loading...
