IBM TS3500 - Performing an Inventory of the Library; Performing an Inventory of a Frame in the Library

About this task
To use the Tape Library Specialist Web interface to licensed and unlicensed capacity and
overall capacity utilization of the TS3500 Tape Library, perform the following steps:
Procedure
1. On the System Summary screen, under Library Status, view Capacity Utilization. If
utilization is at 99%, a yellow indicator will appear. If utilization is 100% or higher, a
red indicator will appear.
2. View licensed and unlicensed capacity under the Total Storage Slots section beneath
All Frames.
Parent topic: Viewing capacity utilization of the library
Performing an inventory of the library
This section introduces two ways to conduct an inventory, or an inventory with audit, of the
TS3500 Tape Library.
To perform an inventory, or an inventory with audit, of the entire TS3500 Tape Library, use
one of the following methods.
• Using the Web to perform an inventory of the library
Complete this task to use the Web to perform an inventory of the library.
• Using the operator panel to perform an inventory of the library
Complete this task to perform an inventory of the library using the operator panel.
Parent topic: Operating procedures
Performing an inventory of a frame in the library
This section introduces two ways to conduct an inventory, or inventory with audit, of a
frame in the TS3500 Tape Library.
To perform an inventory, or an inventory with audit, of a frame in the TS3500 Tape Library,
use one of the following methods.
• Using the Web to perform an inventory of a frame in the library
Complete this task to conduct an inventory of a library frame using the Web.