Operating procedures
This section introduces the procedures that you can perform with the TS3500 Tape Library.
You can operate the library from the operator panel or by using the IBM® System Storage™
Tape Library Specialist Web interface. You can also perform some operations by using the
TS3500 Tape Library Command Line Interface (CLI).
For more information about the CLI, refer to TS3500 Tape Library Command Line
Interface.
• Overview of operating procedures
This section lists the procedures that you can perform with the TS3500 Tape Library.
• Functions of the operator panel
This section contains a flowchart of the procedures that you perform from the operator
panel of the TS3500 Tape Library.
• Functions of the Tape Library Specialist Web interface
This section contains a flowchart of the procedures that you perform from the IBM
System Storage Tape Library Specialist Web interface of the TS3500 Tape Library.
• Operating the library from the operator panel
This section describes how to use the operator panel on the TS3500 Tape Library.
• Operating the library from the Web
This section describes how to use the Web to operate the TS3500 Tape Library.
• Powering on
This section explains the procedure for turning on the power to the TS3500 Tape
Library.
• Powering off
This section explains the procedure for turning off the power to the TS3500 Tape
Library.
• Inserting data or scratch cartridges
This section describes the cartridges that are used by the TS3500 Tape Library and
introduces two ways to insert data and scratch cartridges.
• Removing data cartridges from the library
In addition to removing data cartridges by using your host application software, you
can also use other methods. This section introduces other ways to remove a data
cartridge from the TS3500 Tape Library.
To Next Page
Loading...
