Table 35. Main error events (continued)
Event Code Message Text and
Description
Details and Solution
2004 The Library Startup process
failed.
• Verify that magazines are closed, cartridges are fully seated,
and that no accessor obstructions exist.
• Verify that all modules are powered and any expansion
modules are cabled correctly with the interconnect cable.
• Verify that a top and bottom cover is properly installed on the
library.
• Verify that the module alignment locks (at rear of module)
are in the proper position.
• If the accessor moves front to back, but not vertically, the
accessor shipping lock might be positioned incorrectly and
must be moved to either the fully locked or fully unlocked
position.
• If the error persists, review library events for information or
restart the library.
2005 Cable to accessor is broken. Ensure that the spooling cable is fully seated in the base
module and connected correctly to the accessor assembly.
2009 Library test failed due to
accessor problem.
• Review test requirements and retry the test.
• If the test continues to fail, check for accessor obstructions
or other accessor problems.
• For proper operation, the accessor must be able to reach the
bottom of the library. Verify that no obstructions are at the
bottom of the library or on the bottom cover of the library in
the path of the accessor.
1. To check for obstructions at the bottom of the library, rst
power off the library by pressing Power for 5 seconds and
select the Default Park location.
2. When the library is powered off, remove the left magazine
of the lowest library module, and verify that the entire area
of the bottom cover is free of any objects that might
obstruct the accessor's path.
3. After any obstructions are cleared, replace the magazine,
power the library on, and after the library nishes
initialization and inventory, verify that no further critical
events were generated.
2010 Library test failed due to
spooling mechanism defect.
Ensure that the spooling mechanism is fully seated in the base
module and installed correctly to the accessor assembly.
2012 Multiple bottom covers
detected.
Remove all bottom covers except for the bottom module in the
library.
2013 Multiple top covers detected. Remove all top covers except for the top module in the library.
2014 Bottom cover is missing. Install the bottom cover on the bottom module of the library,
also check the module interconnect cabling and module power
cabling. If the base module can’t detect both a top and bottom
cover, the accessor doesn’t move.
86 IBM TS4300 Tape Library Machine Type 3555: User's Guide
To Next Page
Loading...
Need help?
General
