Figure 100. Attaching the leader pin to the tape
11. Close the pivot arm 4 of the leader pin attach tool by swinging it over the leader pin so that the C-
clip snaps onto the pin and the tape.
12. Swing the pivot arm open and trim the excess tape 5 so that it is flush with the reattached leader pin
6 .
13. Use your ngers to remove the leader pin from the cavity 3 in the leader pin attach tool.
14. Use the cartridge manual rewind tool to wind the tape back into the cartridge (wind the tape
clockwise). Ensure that the leader pin is latched by the pin-retaining spring clips on each end of the
leader pin.
15. Remove the rewind tool.
16. Remove the leader pin attach tool by lifting its end up and away from the cartridge.
Environmental and shipping specications for tape cartridges
Before you use a tape cartridge, acclimate it to the operating environment for 24 hours or the time
necessary to prevent condensation in the drive. The time varies, depending on the environmental
extremes to which the cartridge was exposed. If the data cartridge was exposed to temperatures outside
the specied ranges, stabilize the cartridge at room temperature for the same length of time it was
exposed to extreme temperatures or 24 hours, whichever is less.
The best storage container for the cartridges (until they are opened) is the original shipping container. The
plastic wrapping prevents dirt from accumulating on the cartridges and partially protects them from
humidity changes.
Appendix B. LTO media
171
To Next Page
Loading...
Need help?
General
