48. Full-height FC dual port............................................................................................................................ 53
49. Half-height FC single port.........................................................................................................................53
50. Half-height SAS dual port......................................................................................................................... 54
51. IP address selection................................................................................................................................. 55
52. Open I/O station seen from the left..........................................................................................................57
53. Magazine pulled out..................................................................................................................................57
54. Management GUI main screen................................................................................................................. 62
55. Operator Panel main screen..................................................................................................................... 64
56. Front panel LEDs....................................................................................................................................... 65
57. Internal view of the library..................................................................................................................... 118
58. Drive bay covers......................................................................................................................................120
59. Alignment rails........................................................................................................................................ 120
60. Installing a tape drive............................................................................................................................. 121
61. Unlocking the drive................................................................................................................................. 121
62. Interconnect cables................................................................................................................................125
63. Unlocking or disengaging the alignment lever.......................................................................................126
64. Loosening the thumbscrews.................................................................................................................. 127
65. Sliding the module out of the rack......................................................................................................... 127
66. Placement of the RID tag (Base Module shown)................................................................................... 129
67. Power supplies........................................................................................................................................130
68. Sliding in the new power supply.............................................................................................................131
69. Controller card components...................................................................................................................133
70. Installing a Controller card.....................................................................................................................134
71. Magazine release levers......................................................................................................................... 136
72. Unlocking the robot................................................................................................................................ 137
xiii
To Next Page
Loading...
