Rear view
The following illustration shows the connectors and LEDs on the rear of the server.
Video
Mouse
Power cord
Keyboard
Serial 1
(COM 1)
Parallel
Serial 2
(COM 2)
USB 4
Ethernet 10/100/1000
Ethernet 10/100/1000
RJ-45
USB 3
AC power LED
DC power LED
Power-cord connector: Connect the power cord to this connector.
Mouse connector: Connect a mouse or other PS/2 device to this connector.
Keyboard connector: Connect a PS/2 keyboard to this connector.
Serial 1 (COM 1) connector: Connect a 9-pin serial device to this connector.
Parallel connector: Connect a parallel device to this connector.
Video connector: Connect a monitor to this connector.
USB 4 connector: Connect a USB device to this connector.
Ethernet connector: Use this connector to connect the server to a network.
USB 3 connector: Connect a USB device to this connector.
Ethernet connector: Use this connector to connect the server to a network.
RJ-45 connector: Use this connector to connect the optional Remote Supervisor
Adapter II SlimLine to a network.
Chapter 3. Server controls, connectors, LEDs, and power 37
To Next Page
Loading...
