v  Follow  the  suggested  actions  in  the  order  in  which  they  are  listed  in  the  Action  column  until  the  problem 
is  solved. 
v  See  the  Problem  Determination  and  Service  Guide  on  the  IBM  System  x  Documentation  CD  to  determine  which 
components  are  customer  replaceable  units  (CRU)  and  which  components  are  field  replaceable  units 
(FRU). 
v  If  an  action  step  is  preceded  by  “(Trained  service  technician  only),”  that  step  must  be  performed  only  by  a 
trained  service  technician. 
Symptom  Action 
A  hard  disk  drive  passes  the 
diagnostic  Fixed  Disk  Test,  but 
the  problem  remains. 
Run  the  diagnostic  SCSI  Fixed  Disk  Test  (see  Problem  Determination  and  Service 
Guide  on  the  IBM  System  x  Documentation  CD). 
Note:  This  test  is  not  available  on  servers  that  have  RAID  arrays  or  servers  that 
have  SATA  hard  disk  drives.
 
Intermittent  problems 
 
v  Follow  the  suggested  actions  in  the  order  in  which  they  are  listed  in  the  Action  column  until  the  problem 
is  solved. 
v  See  the  Problem  Determination  and  Service  Guide  on  the  IBM  System  x  Documentation  CD  to  determine  which 
components  are  customer  replaceable  units  (CRU)  and  which  components  are  field  replaceable  units 
(FRU). 
v  If  an  action  step  is  preceded  by  “(Trained  service  technician  only),”  that  step  must  be  performed  only  by  a 
trained  service  technician. 
Symptom  Action 
A  problem  occurs  only 
occasionally  and  is  difficult  to 
diagnose. 
Make  sure  that: 
v  All  cables  and  cords  are  connected  securely  to  the  rear  of  the  server  and 
attached  devices. 
v  When  the  server  is  turned  on,  air  is  flowing  from  the  rear  of  the  server  at  the  fan 
grille.  If  there  is  no  airflow,  the  fan  is  not  working.  This  can  cause  the  server  to 
overheat  and  shut  down.
If
  the  problem  remains,  call  for  service.
 
 
Chapter  5.  Solving  problems  79