59
12 DIGITAL MODE OPERATION
Your call sign programming—continued
z Push [BANK/OPTION] for 1 sec. then
push [BANK/OPTION] or [MR/CALL] to
select the call sign select mode.
• “MYC” appears.
x Push [
YY
] or [
ZZ
] to select the desired call
sign channel then push [
SET
B(D-OFF)].
c Push [
SET
B(D-OFF)] to set into call sign
programming mode.
• The 1st digit blinks and channel indication
stops blinking.
v Push [
YY
] or [
ZZ
] to set the desired charac-
ter or code.
• Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] to
move the cursor to left or right, respectively.
b Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] to
select 2nd digit, then push [
YY
] or [
ZZ
] to set
the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming your call
sign.
n Push [
CLR
A(MW)] to fix the call sign and
exit programming condition.
DD
Station/Repeater1/2 call sign programming
Station call sign must be programmed for the specified sta-
tion call as well as repeater operation in both Digital voice and
slow data communications.
q Push [BANK ] for 1 sec. then push [BANK ] or
[V/MHz] several times to select the call sign select mode.
• “YUC” appears for station call sign.
• “R1C” or “R2C” appears for repeater call sign.
w Rotate [DIAL] to select the desired call sign channel then
push [SET] or [MONI].
e Push [MONI] (or [SET]) to set into call sign programming con-
dition.
• The 1st digit blinks and channel indication stops blinking.
r Rotate [DIAL] to set the desired character or code.
• Push [MONI] or [SET] to move the cursor to left or right, re-
spectively.
To Next Page
Loading...
