60
12
DIGITAL MODE OPERATION
12
t Push [MONI] (or [SET]) to select 2nd digit, then rotate
[DIAL] to set the desired character or code.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming station/repeater call sign.
y Push [V/MHz] to fix the call sign.
u Rotate [DIAL] to select an another channel from “C1” to
“C6.”
i Repeat steps w to y to program another station/repeater
call sign channels.
✔
For your information:
Station and/or repeater call sign can be programmed from
Received call record when a call is received.
See page 64 for details.
✔
For your information:
Repeater call sign can be programmed gateway connection
capabilities at step r for connecting to the other Area or
Zone.
• “G” appears or disappears at the 8th digit when each pushing [LOW].
z Push [BANK/OPTION] for 1 sec. then
push [BANK/OPTION] or [MR/CALL] to
select the call sign select mode.
• “YUC” appears for station call sign.
• “R1C” or “R2C” appears for repeater call sign.
x Push [
YY
] or [
ZZ
] to select the desired call
sign channel then push [
SET
B(D-OFF)].
c Push [
SET
B(D-OFF)] to set into call sign
programming mode.
• The 1st digit blinks and channel indication
stops blinking.
v Push [
YY
] or [
ZZ
] to set the desired charac-
ter or code.
• Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] to
move the cursor to left or right, respectively.
b Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] to
select 2nd digit, then push [
YY
] or [
ZZ
] to set
the desired character or code.
• 2nd digit blinks (1st digit stops blinking).
• Repeat this step for programming your call
sign.
n Push [
CLR
A(MW)] to fix the call sign and
exit programming condition.
NOTE: The digital repeater for an amateur radio operation is
not available at present of December 2003. It will be de-
signed in the future.
To Next Page
Loading...
