9
2
UNIT DESCRIPTION
2
y PRIO/SET•P KEY
PRIO
SETP
N
(PRIO/PRIO Set)
Push to select the Priority channel. (p. 17) ➥
Hold down for 2 seconds to set the displayed channel ➥
as the Priority channel. (p. 17)
F
(S-Ring/PRIO Clear)
Push to transmit the Smart-Ring signal. (p. 40) ➥
• When “TSQL” is displayed, beeps sound.
• When “TSQL” is not displayed, “N/A” appears.
Hold down for 2 seconds to cancel the Priority channel ➥
setting. (p. 17)
u SCAN/TAG KEY
SCAN
TAG
N
(Scan/Scan Tag)
Push to start or stop the scan. (pp. 30, 31) ➥
Hold down for 2 seconds to set or clear the displayed ➥
channel as TAG (scanned) channel. (p. 29)
• “ ” appears when the selected channel is tagged.
F
(TX Code CH/Call)
Push to enter the SelCall TX code Channel Selection ➥
mode, then push
or to select (CB channel op-
eration only.) (p. 35)
Hold down for 2 seconds to transmit on the SelCall TX ➥
code channel. (CB channel operation only) (p. 37)
i FUNCTION DISPLAY (p. 10)
Displays a variety of information such as an operating
channel number/name, SelCall code, selected function
and so on.
o POWER KEY (p. 14)
Hold down for 2 seconds to turn the power ON or OFF.
!0 FUNCTION/SET KEY
F
SET
N
(Function/Set Mode)
Push to turn ON the Function mode. ➥
• “F” appears when Function mode is turned ON.
Hold down for 2 seconds to enter the Set mode. (pp. ➥
19, 20)
F
(Function/RX VFO)
Push to turn OFF the Function mode. ➥
• “F” disappears when the Function mode is turned OFF.
Hold down for 2 seconds to enter RX VFO mode. ➥
(‘RX-XX’ appears while an RX channel is selected) (p. 35)
NOTE: Automatically returns to the Normal mode after
30 seconds, when no Key operation is performed in
Function or Set mode.
!1 MONI/T SQL KEY
MONI
TSQL
N
(Monitor/TSQL)
Push to turn the Monitor function ON or OFF. (p. 18) ➥
Hold down for 2 seconds to sequentially activate the ➥
following functions:
• Subaudible tone encoder and Tone squelch/DTCS squelch
(“TSQL” appears). (p. 34)
• Pocket beep (“TSQL ë” appears). (p. 34)
• No tone operation (“TSQL ë” disappears).
F
(SQL/ATS)
Push to enter the Squelch level setting mode, then ➥
push
or to set the squelch level. (p. 18)
Hold down for 2 seconds to turn the ATS (Automatic ➥
Transponder System) function ON or OFF. (p. 40)
To Next Page
Loading...
