Icom IC-440N - Receiving and Transmitting

15
3
BASIC OPERATION
3
Zone type selection D
(Available only when more than two zones are set.)
Push q
F
SET
(Function) to enter the Function mode, and hold
down
LOW
(Zone) for 2 seconds to enter the zone select
mode.
Push w or to select the desired zone, then push
LOW
(Zone) again to set it.
NOTE:
• ‘CB-05,’ ‘RPT-05’ and ‘CB-35’ channels are used for
emergency.
• No voice transmissions are permitted on ‘CB-22’ and
‘CB-23’ (voice operation is inhibited on these channels.)
Receiving and transmitting ■
Receiving:
Hold down q
for 2 seconds to turn ON the power.
• If “T SQL” appears on the display, hold down
MONI
TSQL
for 2 sec-
onds once or twice to cancel the tone squelch or pocket beep.
(pp. 34, 35)
Select the desired operating channel (p. 14). w
• When receiving a signal, “ ” appears and audio is heard from
the speaker.
• Further adjustment of volume level may be necessary at this
point. (p. 7)
• Push
MONI
TSQL
to toggle the Monitor function ON or OFF.
MONI
F
SET
TSQL
PRIO
LOW
SCAN
O࡮G࡮P
CH
SET࡮P
RS
TAG
SQL
[PWR]
LOW
MONI
TSQL